Approve the Residential Clothes Washers UES measure update as presented:

• For RMC use average per configuration
• For Hot water use average per configuration
• Change the Category to “Proven”
• Keep the Status at “Active”
• Set the sunset date to December 31, 2025

Extend the Sunset Date for the Commercial Clothes Washers UES measure to February 2021.

Approve the Commercial Boiler Systems Standard Protocol and associated Calculator as presented.

• Set the Status to Active. 
• Set the Sunset Date to November 30, 2025.

Approve the updates to the New Homes Standard Protocol as presented, including:

• Accept the component UES updates as presented
• Continue using REM with no back-end adjustments to HVAC savings until informative evaluation results are available
• Set the Sunset Date to January 2022

Adopt updates to the ENERGY STAR Commercial Fryers UES measure as presented, and:

• Set the Category to:
  • Small Saver for Electric applications
  • Planning for Natural Gas applications
• Set the Status to Active
• Set the Sunset Date to May 31, 2021
• Adopt updates to the existing Research Strategy for Food Service measures. 
   

Extend the sunset date for the following measures to December 2020:

• Residential Clothes Washer UES
• Residential Clothes Dryer UES
• Commercial Clothes Washer UES

Adopt the proposed research strategy and change the ASHP Conversion and Upgrade measure status from Under Review to Active.

Approve updates to the Residential Lighting measure as proposed and set the Sunset Date to September 30, 2022, with the following details:

• For screw-base lamps
  • Remove the Unsolicited Mail delivery mechanism
  • Keep the Category at Proven
  • Keep the status at Active
• For Pin-based lamps:
  • Remove the Unsolicited Mail delivery mechanism
  • Keep the Category at Small Saver
  • Keep the status at Active
• For Fixtures
  • Keep both the retail and direct install delivery mechanism
  • Remove the linear flush mounts
  • Keep the Category at Proven
  • Keep the status at Active

Adopt the ENERGY STAR Refrigerated Beverage Vending Machine measure as presented, and:

• Set the Category to Small Saver
• Set the Status to Active
• Set the Sunset Date to August 31, 2025
• Calculate incremental costs as a weighted average of costs for CO2 (25%) and Propane (75%) coolants.

Updated the Voltage Optimization Standard Protocol as presented:

• Keep the Status at Active
• Set the Sunset Date to July 2025

Approved the updates to the Low-Rise Multifamily Weatherization Research Strategy as presented. 

Kept the Engine Block Heater Controls Planning UES measure as-is, extended the sunset date to July 31, 2023, and adjusted HZ1 plug in schedule to December through February.

Approve the updates to the Multifamily Low-Rise Weatherization UES Measures as presented, and 

• Keep/Set the Categories at Planning for Zonal Electric and Gas and Small Saver for all others 
• Review and confirm the research strategy (especially on sample size), report back to RTF
• Provide only the "Any AFUE" measure, set at 80 AFUE
• Keep the Status as Active
• Set the Sunset Date to June 2023.

Adopt  the Commercial ENERGY STAR Ice Maker UES measure as presented and set the Category to Small Saver, Set the Status to Active, Set the Sunset date to June 30, 2025.

Approve updates to Circulator Pumps UES measure as presented. Keep the Category at Planning, Keep the Status at Active, Set the sunset date to June 30, 2023.

Approve the updates to the Thermostatic Shower Restriction Valve UES measure as proposed and keep the Category at Planning, keep the Status at Active, and set the sunset date to June 30, 2023.

Extend the sunset dates for the New Homes Standard Protocol and School Weatherization UES measures to September 2020.

Accept the updates to the New Manufactured Home and HVAC UES measures as proposed, and specifically:

• Keep the Category Planning
• Set the Status to Active
• Set the sunset date to May 2023
• Set the fraction of heat pumps to 40%
• Zero-out the supplemental NEI's

Extend the sunset date for the New Manufactured Homes and HVAC UES measure to July 2020. 

Approve the Consumer HPWH in Commercial Applications UES measure as proposed, add Groceries into the the high use category, change measure life to ASHP measure, set the Category to Planning, adopt the Research Strategy as outlined. Set the status to Active. Set the sunset date to January 2021.

Approve the single-family and manufactured home SEEM calibrations for natural gas with these modifications:

• Zero out 'electric heat' MH Phase II adjustment

Extend the sunset date for the ENERGY STAR Commercial Refrigerators and Freezers measure to March 31, 2025.

Extend the sunset date for the following measures to June 30, 2020: 

• Commercial and Residential Showerheads
• Thermostatic Shower Restriction Valves

Deactivate the SF and MH Commissioning, Controls and Sizing UES measure and consider any future new measure proposal from utility stakeholders. 

Approve the updates to the Non-residential Lighting Midstream UES as Presented:

• For T8 Replacement TLED share assume:
  • Option 2: 26% based on NEEA analysis only
• Keep the Category as "Proven"
• Keep the status at "Active"
• Set the sunset date to November 30, 2020

Extend the sunset date for the Residential Connected Thermostats UES measure to December 31, 2020

Approve the updates to the Residential Manufactured Homes Weatherization Measure as presented and:

• Set Category to Planning
• Set Status to Under Review
• Set the Sunset date to November 30, 2022
• Review, and if needed update ASHP sizing assumptions base on BPA CC&S dataset and any additional data to inform heat pump sizing for ASHP measure
• Adjust the measure life for infiltration to 25 years
• Adjust the Phase 1 Calibration factor for this measure from 0.5 to 0.6
• During the QA/QC process, add a 10% infiltration reduction to window upgrade and retrofit measure application in the SF Weatherization analysis

Adopt the updates to the Residential SF Weatherization Measures as presented and:

• Set the Category to Planning 
• Set the Status to Under Review
• Set the Sunset Date to Oct. 31, 2022
• Review, and if needed update, ASHP sizing assumptions based on BPA CC&S data set

Adopt the updates as presented to the DHPs for Zonal Heat SF and MH measure

• Set the Category to Proven for SF and Small Saver for MH
• Set the measure status to Active 
• Set the sunset date to October 31, 2024
• Direct staff to explore: 
  • screen with a combined VBDD R2 + temperature sensitive consumption, and
  • screen with supplemental fuels only

          and present to the RTF at a later date. 

Extend the sunset date for the following measures to December 2019:

• Commercial Grocery Anti-sweat Heater Controls UES
• Residential Refrigerator/Freezer Decomissioning UES

Approve the 'simplest-case' Phase I regression, as described in slide 58:

• Use a single slope coefficient based on SEEM.EUI, a separate constant for each heating system, and no other variables.

Approve Phase II of the calibration, as presented. 

Extend the sunset date for the Multifamily New Construction (ID and MT) UES to June 2020. 

Approve the single-family phase 1 calibration (v. 2.2) as presented, and direct staff to conduct a check on the electric calibration using consumption and other best available data and report back with findings. 

Approve the Strip Curtain UES as presented and change the sunset date to July 30, 2024.

Approve the  recommended methodology for estimating maximum technical per unit potential of Refrigerated Warehouses as presented. 

• In approving this the RTF recognizes that additional factors will need to be considered to estimate achievable potential, including the considerations listed in the presentation. 

Extend the sunset date for the Floating Head Pressure Controls UES to September 2019
Extend the sunset date for the following measures to November 2019:

• ASPH upgrades SF
• CC&S SF
• ASHP Upgrades and Conversions MH
• CC&S MH
•  MH Weatherization (Heat Pumps)
• DHP in Zonal Electric Resistance Homes SF
• DHP in Zonal Electric Resistance Homes MH
• SF Weatherization 

The RTF endorses the findings and recommendations provided in the executive summary of the whole building white paper, and directs that the RTF staff engages in further activities as presented.

Deactivate Slab Insulation UES.

Adopt the updates to the Residential Electronic Thermostats measure as presented:

• Keep the Status as Active
• Keep the Category at Planning
• Change the assumed number of retrofitted thermostats per home to 5 for SF and 3 for MF
• Assume that DHP/Hybrid applications have one fewer thermostat per home retrofitted
• Use both RBSA I and RBSA II by heating zone and heating system type in calculating heating consumption
• Change the Measure Name to 'Residential Electronic Line Voltage Thermostats'
• Set the Sunset Date to April 30, 2022. 

Approve the updates to the Display Case Evaporator Fan Motor Retrofit to ECM UES measure as presented and:

• Change the measure name to “Display Case Evaporator Fan Motor Retrofit”
• Keep the Category at Small Saver
• Keep the Status at Active
• Set the Sunset Date to May 31, 2021

Adopt the updates to the Standard Information Workbook as presented with the following modifications:

• Update market rate modifier from 1.5 to 2.0 for skilled labor rates;
• Except the air source heat pump costs.

Approve the updates as presented to the Commercial Low Flow Showerhead measure.

• Change the measure identifier from 1.75 to 1.8 gpm or less and update the savings to the extent that they are affected
• In-situ flow adjustment of 0.9
• Change retail delivery mechanism to wholesale
• Add embedded water energy savings to TRC
• Keep the category at Small Saver
• Keep the status at active
• Set the sunset date to February 28, 2020

Approve the per unit demand response savings estimates for Networked Residential Level 2 AC EV Chargers as presented.

Extend the sunset date for the Ductless Heat Pumps for Zonal Heat Single Family and Manufactured Homes measures to June 2019, and set the measure status to Under Review. 

Extend the sunset date for the following measures to July 2019:

• Manufactured Home ASHP Upgrades
• Manufactured Home  ASHP Conversions
• Manufactured Home Weatherization (Heat pumps)
• Manufactured Home Commissioning Controls and Sizing

Approve the methodology for mapping locations to available weather data and for selecting weather locations for building simulation in measure assessments. 

Adopt the Commercial Glazing Systems UES measure as proposed:

• set the Category to Planning;
• set the Status to Active; and 
• set the Sunset Date at November 30, 2021

Approve the updates to the Commercial Advanced Power Strips UES measure savings, costs, lifetime, and Research Strategy as presented and:

•  Keep the Category at Planning
• Keep the Status at Active
• Set the sunset date to November 30, 2021
• Look at other savings shapes and revise to make consistent with the Plan for this measure and report back to the RTF

Approve the analysis updates for the Residential Lighting UES measure as presented:
For Screw-base Lamps: 

• Keep the Category at Proven
• Keep the Status at Active
• Remove top two lumen bins for Globe lamps

For Pin-Base Lamps:

• Keep the Category at Small Saver
• Keep the Status at Active

For Fixtures:

• Keep the Category at Planning
• Keep the Status at Active
• Maintain the existing Research Strategy
• Remove LDL from specification

For all applications:

• Set the sunset date to December 31, 2019 to update sales and baseline data